Print the file and see if it gets past that and heats the hot end and continues to homing. That will turn it into a comment instead of a command. So open the Gcode file in Notepad and put a semi-colon in front of the M190 S60 line. Since your printer has a heated bed then it shouldn't hang there. Some other machines had that problem but they were printers without heated beds (so they would wait forever). If your machine isn't getting to the G28 Auto-Home lines, and the hot end temp is falling, it's probably hanging on the M190 line. I always pre-heat both the bed and nozzle. The machine waits for the bed to heat, then the extruder heats, and then the machine waits for that to finish. With the bed and hot end pre-heated, the Gcode starts with the bed heating.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |